To be able to use the full range of Shopware 6, we recommend activating Javascript in your browser.

Elektro-Installation

- The conduit entries are secured against accidental opening due to impacts from reinforcement steel or kicks
- Open conduit entries are easily identified during inspections thanks to the junction box’s two colours
- Horizontal and vertical slits in the sealing membrane enable the marking cross on the formwork to be seen through the membrane
- Two-part design
- Version with tunnel extension (Art.-No. 9907.30) accommodates a driver for LED strip lighting in residential buildings

Concrete construction

- Compatible with Feller SNAPFIX®
- Suitable for screw or claw fixing of accessories
- For device screws Ø 3 mm
- Max. tightening torque 0.5 Nm
- With injection-moulded signal cover
- For assembling combinations, centre distance 60 mm
- Low-lying plaster grips

Flush-mounted

- Compatible with Feller SNAPFIX®
- for plate thickness > 10 - 40 mm
- Airtight design with sealing membranes
- Toolless pipe inlets
- For Ø 20 mm and Ø 25 mm
- No shadow gaps of the covers
- Pipe inlet 90° swivelling

Hollow wall

- 5-pole input and output, including locks, for a 3-phase power supply.
- Cover with (2+2)x3p chassis parts, including locks, power supply from L1 and L2.
- Pre-shaped plastic assembly bracket for quick click-assembly on all common cable ducts.
- Wiring: 2.5 mm²
- Set of mounting brackets for quick "click" mounting on all common cable trays

Plug-in installation

- Compatible with Feller SNAPFIX®
- for F30-F90 or EI30-EI90 fire-protection walls
- For timber stud walls F30-F90 or EI30-EI90
- VKF approval 21042
- also for opposing installation
- for plate thickness > 10 - 40 mm
- matching plug-in cover for Art. No. 9498-77 New Look one Art. No. 9919.10
- For device screws Ø 3 mm
- Max. tightening torque 0.5 Nm

Prefix® concrete boxes for fastening to reinforcement

- Toolless combination entry for M20/M25 conduits
- Conduit entry limitation to prevent the need to shorten the conduit inside

Installation enclosure

- For cable introductions
- With plug-in cover
- Halogen-free

Surface-mounted

- for cables 4 - 25 mm² or round conductors up to Ø 6.6 mm
- low contact resistance due to two terminals

Earthing / potential equalisation

Feller SNAPFIX® compatible products

- Two-part design with secure catch mechanism
- Air-tight component closure for front and rear installation in the boarding of wall elements or modules
- Flexible cable pull-in from both directions thanks to 90° bend without abutting edges
- Wall connection element can be used on both sides for 90° bends and electrical conduit
- Flat collar for a firm and flush fit in the wall element

Modular and prefabricated house construction

- With holder and centring drill
- Fits all electric drills with 13 mm chuck
- For junction boxes Art. No. 9073-01/-78 and 9273-92/-78 as well as installation housing 9273-50

Tools

- Standard design for all common tubes
- special designs "made to measure

Press ring sealing inserts